| | |
|
|
|
|
Jeff C. running the forklift to move the combo into the shop. - James Kolanowski (jamesk) Viewed: 2330 times.
|
The combo freshly rebuilt at the machine shop. - James Kolanowski (jamesk) Viewed: 2453 times.
|
November 26th, the Bay City crane moves the roof off of the drop table. - Richard Schauer (rwschauer) Viewed: 2491 times.
|
| | |
| | |
|
|
|
|
The combo moved out of the doorway to move the skid of rollers back in. Note the axle cover that says "Lat .079", the before lateral measurement was .350, just a bit out of spec. - Richard Schauer (rwschauer) Viewed: 2478 times.
|
Jamie, Dan and Roger mounting the roller bearings on the end of the axle. - Richard Schauer (rwschauer) Viewed: 2317 times.
|
098.JPG - Richard Schauer (rwschauer) Viewed: 1999 times.
|
| | |
| | |
|
|
|
|
The drop table pit and mechanism. - Richard Schauer (rwschauer) Viewed: 2104 times.
|
The drop table ready for service. - Richard Schauer (rwschauer) Viewed: 2013 times.
|
8537 was used to push the 6847 out of the steam shop and onto the drop table. - Richard Schauer (rwschauer) Viewed: 2074 times.
|
| | |
| | |
|
|
|
|
The #5 axle is lined up over the drop table. - Richard Schauer (rwschauer) Viewed: 2180 times.
|
Measuring where the center of the wheels should go so everything lines up as close as possible. - Richard Schauer (rwschauer) Viewed: 2027 times.
|
Loading the combo onto the drop table. - Richard Schauer (rwschauer) Viewed: 1946 times.
|
| | |
| | |
|
|
|
|
Blocking up the motor. - Richard Schauer (rwschauer) Viewed: 1881 times.
|
checking to make sure everything clears properly, including the motor blower duct. - Richard Schauer (rwschauer) Viewed: 1910 times.
|
The roller bearing boxes are lined up to slide into the pedestals as the table is raised. - Richard Schauer (rwschauer) Viewed: 2035 times.
|
| | |
2
