| | | |
|
|
|
|
Mike and Ed drill out the rivet holes - Nigel Bennett (nbennett) Viewed: 1801 times.
|
Firebox corner now prepared for riveting - Nigel Bennett (nbennett) Viewed: 1728 times.
|
Preparing the safe end tubing - Nigel Bennett (nbennett) Viewed: 1701 times.
|
Phil preparing to sand blast - Nigel Bennett (nbennett) Viewed: 1732 times.
|
| | | |
| | | |
|
|
|
|
Cutting safe ends for super heater flues - Nigel Bennett (nbennett) Viewed: 1759 times.
|
All the safe ends are now cut - Nigel Bennett (nbennett) Viewed: 1635 times.
|
Each end must be tapered to fit into the flue - Nigel Bennett (nbennett) Viewed: 1699 times.
|
The taper is cut in the lathe - Nigel Bennett (nbennett) Viewed: 1715 times.
|
| | | |
| | | |
|
|
|
|
New piston rod for the McCabe - Nigel Bennett (nbennett) Viewed: 1695 times.
|
The tender tank top is now much improved - Nigel Bennett (nbennett) Viewed: 1705 times.
|
Pressure tester for flues - Nigel Bennett (nbennett) Viewed: 1693 times.
|
The piston rod is now back in the McCabe - Nigel Bennett (nbennett) Viewed: 1651 times.
|
| | | |
| | | |
|
|
|
|
Removing stay caps - Nigel Bennett (nbennett) Viewed: 1616 times.
|
Inside a flexible stay - Nigel Bennett (nbennett) Viewed: 1676 times.
|
This where the element fits into the header - Nigel Bennett (nbennett) Viewed: 1613 times.
|
Dennis welds the tube sheet - Nigel Bennett (nbennett) Viewed: 1659 times.
|
| | | |
| | | |
|
|
|
|
Flues now ready for welding - Nigel Bennett (nbennett) Viewed: 1672 times.
|
McCabe piston now back in place - Nigel Bennett (nbennett) Viewed: 1702 times.
|
Paul cleaning super heater elements - Nigel Bennett (nbennett) Viewed: 1748 times.
|
This is how the elements are tested - Nigel Bennett (nbennett) Viewed: 1696 times.
|
| | | |